7
Introduction
3. Configuring the system
After installing and connecting all stations, the system will need to be fully configured before it will be operational.
IX system can be configured in one of the two methods below. Choose one method. Using the "IX Support Tool" (1) is
recommended.
(1) Configure using the "IX Support Tool" application
– Install the application on a PC and use to create the configuration for all stations.
– Search for IX systems on the network; assign and upload configuration data for the system.
(2) Configure each station through a web browser (web configuration)
– Access each station through a web browser, and configure each station individually.
– When configuring a station without using IX Support Tool, settings must be manually input and the setting data
must be individually stored.
Important
• Once the system has been configured through a browser, the settings cannot be transferred to the IX Support Tool. Using the
IX Support Tool is the recommended method to manage settings.
• If web browser configuration is used to change the "Identification"
“Number♦♣ (→page 52)”, "ID and Password" “Administrator
ID♦♣ (→page 53)” “Administrator Password♦♣ (→page 53)”, "IPv4 Address" “IP Address♦♣ (→page 59)” and "IPv6 Address"
“IP Address♦♣ (→page 59)” after configured using the IX Support Tool, it will not be applied to the IX Support Tool settings.
To Next Page
Loading...
