31
Introduction
4.5 For IPv6 Address with DHCP
4.5.1 Create new data
Use this flowchart to create a new setting file, for example, when installing a new system.
Important
• Save the setting file after configuring the system. Refer to “Settings File Backup (→page 90)”.
• If the setting data is not saved, it may be impossible to restore if post-installation service or maintenance is required.
1. Verify managed DHCP environment exists and that each station has been assigned a static
IP address.
Configure the system so that the DHCP server assigns a static IP address to each station. The DUID of the station is
"00030001 + MAC address."
Refer to the DHCP server's manual for information on how to configure the DHCP server.
2. Connect PC to the station to be configured.
The default IP addresses of the stations are identical. Connect one at a time.
“Connecting to a PC (→page 41)”
3. With default IPv4 Address (192.168.1.160), log in to the Web server of the station to be
configured.
“Log in to the Web server of the station to be configured (→page 42)”
4. Set "Static / DHCP" to "IPv6 DHCPv6."
“Static / DHCP (→page 58)”
The station is restarted and the IPv6 address assigned by the DHCP server beforehand will be assigned. If an IP address
cannot be assigned, it will default to "FDC2::7000." If this happens, cycle power to the station, and then the IP address will
be assigned again.
5. Configure other stations to be "IPv6 DHCPv6" in the same manner.
6. Log in to the Web server of the station with the assigned IPv6 address.
“Log in to the Web server of the station to be configured (→page 42)”
To Next Page
Loading...
