30
Introduction
4.4.5 Replace a station
Use this flowchart to replace a station.
Support Tool is needed to configure the system using this flowchart. Install Support Tool, and set for IPv6. For set up
information, refer to "IX Support Tool Setting Manual."
Can the web server of the station to be replaced be accessed?
YES NO
1. Download the settings of the station to be
replaced.
“Settings File Backup (→page 90)”
1. Replace the station.
2. Replace the station. 2. Upload the stored setting file to the newly
installed station.
If the station settings were modified after being stored,
those changes will not be reflected.
“Settings File Backup (→page 90)”
The station is restarted and the IPv6 address is
automatically configured.
3. Upload the stored setting file to the newly
installed station.
“Settings File Backup (→page 90)”
4. Search using IX Support Tool for each new
station's IPv6 Address.
3. Search using IX Support Tool for each new
station's IPv6 Address.
5. Update the IPv6 address of the replaced
station that was registered in other stations
and software.
4. Update the IPv6 address of the replaced
station that was registered in other stations
and software.
6. Complete. 5. Complete.
To Next Page
Loading...
