25
Introduction
4.4 For Stateless IPv6 Address
4.4.1 Create new data
Use this flowchart to create a new setting file, for example, when installing a new system.
Support Tool is needed to configure the system using this flowchart. Install Support Tool, and set for IPv6. For set up
information, refer to "IX Support Tool Setting Manual."
Important
• Save the setting file after configuring the system. Refer to “Settings File Backup (→page 90)”.
• If the setting data is not saved, it may be impossible to restore if post-installation service or maintenance is required.
1. Install a device (e.g., router) which can transmit RA (supports the stateless IPv6 setting).
Do not change the device so that it cannot transmit Router Advertisements (RA). For how to set up, refer to the manual of
the device.
2. Connect PC to the station to be configured.
The default IP addresses of the stations are identical. Connect one at a time.
“Connecting to a PC (→page 41)”
3. With default IPv4 Address (192.168.1.160), log in to the Web server of the station to be
configured.
“Log in to the Web server of the station to be configured (→page 42)”
4. Set "Static / DHCP" to "IPv6 Stateless."
“Static / DHCP (→page 58)”
The station restarts and an IPv6 address is automatically configured. If the IP address fails to be automatically configured, it
will become "FDC2::7000." If this happens, cycle power to the station, and then the IP address will be automatically
reconfigured.
5. Configure other stations to be "IPv6 Stateless" in the same manner.
6. Search each station with Support Tool for its IPv6 address.
To Next Page
Loading...
