28
Introduction
4.4.3 Add a station
Use this flowchart to add a station.
Support Tool is needed to configure the system using this flowchart. Install Support Tool, and set for IPv6. For set up
information, refer to "IX Support Tool Setting Manual."
1. Connect PC to the station to be added.
Connect stations one at a time to avoid IP address conflict.
“Connecting to a PC (→page 41)”
2. With default IPv4 Address (192.168.1.160), log in to the Web server of the station to be
added.
“Log in to the Web server of the station to be configured (→page 42)”
3. Set "Static / DHCP" to "IPv6 Stateless."
“Static / DHCP (→page 58)”
The station restarts and an IPv6 address is automatically configured. If the IP address fails to be automatically configured, it
will become "FDC2::7000." If this happens, cycle power to the station, and then the IP address will be automatically
reconfigured.
4. Search each station to be added with Support Tool for its IPv6 address.
5. Log in to the web server of the station with the IPv6 Address that have been identified.
“Log in to the Web server of the station to be configured (→page 42)”
6. Set “Language (→page 54)”.
Click [Update] to update the settings.
7. Configure the station.
“Configuring the Station (→page 51)”
8. Add settings data to existing stations if required.
9. Complete.
To Next Page
Loading...
