34
Introduction
4.5.3 Add a station
Use this flowchart to add a station.
1. Configure the DHCP server to assign a static IP address.
The DUID of the station is "00030001 + MAC address."
For how to set up the DHCP server, refer to its manual.
2. Connect PC to the station to be added.
Connect one at a time.
“Connecting to a PC (→page 41)”
3. With the default IPv4 Address(192.168.1.160), log in to the web server of the station to be
added.
“Log in to the Web server of the station to be configured (→page 42)”
4. Set "Static / DHCP" to "IPv6 DHCPv6."
“Static / DHCP (→page 58)”
The station is restarted and the IPv6 address assigned by the DHCP server beforehand will be assigned. If an IP address
cannot be assigned, it will default to "FDC2::7000." If this happens, cycle power to the station, and then the IP address will
be assigned again.
5. Log in to the web server of the station with the assigned IPv6 Address.
“Log in to the Web server of the station to be configured (→page 42)”
6. Set “Language (→page 54)”.
Click [Update] to update the settings.
7. Configure the station.
“Configuring the Station (→page 51)”
8. Add settings data to existing stations if required.
9. Complete.
To Next Page
Loading...
