1.3 Permissible operating conditions/places of use
Follow the instructions on permissible operating conditions in the user manual of your wheelchair to which the e-motion is attached. Any
limitations on permissible operating conditions (e.g. maximum climbing capacity, maximum permissible obstacle height, maximum user
weight, etc.) must also be observed when operating the e-motion!
The e-motion can be operated only at temperatures between -25 °C and +50 °C.
Avoid travel on non-solid surfaces (e.g. on loose gravel, sand, mud, snow, ice or through deep puddles).
Follow the safety instructions and hazard notes in Chapter 11.
1.4 Standard scope of delivery
- two e-motion wheels
- two battery packs (maintenance free)
- two protective covers for the wheel contacts
- two protective covers for the battery contacts
- one mains charger inc. operating instructions
- These operating instructions
The wheelchair must have special brackets for attaching the e-motion. If this is not the case, please contact your specialist dealer directly
or one of the Alber factory representatives.
1.5 Optional accessories
- Rechargeable battery pack / spare battery
- Anti-tippers for the wheelchair
- Remote control
- Bracket for remote control
- Spoke cover
Use only original Alber accessories.
The e-motion is designed to yield superb performance when using with original Alber accessories. Alber is not liable for damages on the
product or accidents (e.g. fires, etc.) caused by a malfunction of non-original accessories or spare parts (e.g. leakage or explosion of a bat-
tery pack). The warranty does not cover any repair required due to a malfunction of non-original accessories. However, you may commis-
sion repairs on a chargeable basis.
USA / Canada
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the users’ authority to operate the
equipment.