2. Start-up
The e-motion wheels and, if applicable, the accessories you ordered are mounted to your
wheelchair by Alber or your specialist dealer and delivered to you ready for operation.
Both sides of your wheelchair are therefore equipped with new brackets [15] with wheel
receivers into which the two e-motion wheels are inserted (see Chapter 2.1). The manual
wheelchair wheels which you have previously used are also returned to you for possible
future use.
When the e-motion is delivered to you, your specialist dealer will instruct you about the
operation of the system and the accessories you may have ordered. He will also hand the
operating instructions to you which contain important information on driving, in addition
to the technical information.
The brackets [15] may only be mounted to the wheelchair by Alber
or a specialist dealers authorized by Alber.
Regularly inspect and check the brackets [15] to verify that they
are tightly and securely screwed onto the wheelchair. If these
screw connections have become loose or have even unscrewed, you
must have them retightened by an authorized specialist dealership.
Failure to do so can cause the wheels to detach and serious bodily
injury.
Alber manufactures brackets in different designs, for example, as a
complete single part or made up of separate parts. For this reason,
graphic representations in this operating manual may differ from
the bracket mounted to your wheelchair.
To Next Page
Loading...
