Installing Your Switch
Page 36 7210 SAS-M Installation Guide
Installing Your Switch
Rack Mounting
If you plan to rack-mount your switch, make sure you have the following equipment available:
• Four mounting screws for each device you plan to install in a rack (not included)
• A screwdriver (Phillips or flathead, depending on the type of screws used)
To rack-mount your 7210 SAS-M:
Step 1 Attach the brackets to the device using the screws provided in the Bracket Mounting Kit.
See Figure 10.
Figure 10: Attaching the Brackets
Step 2 Mount the 7210 SAS-M in the rack, using four rack-mounting screws (not provided). See
Figure 11.
To Next Page
Loading...
