Configuring the 7210 SAS-M
7210 SAS-M Installation Guide Page 51
Initializing the System and Downloading Software
The 7210 SAS-M ships with bootloader and TiMOS in flash. When the system is powered up for
the first time, the bootloader will attempt an auto-init procedure (see the System Basics Guide for
more information). The auto-init can, however, be interrupted and the boot operation can be
controlled manually.
Booting a 7210 SAS-M in the Lab
There are several ways to boot the 7210 SAS-M from the network. User can choose to boot the
device using one of the following options:
• Using the image shipped along with the box to boot the device
• Using the network to load the image and boot the device
The following sections describe how to boot the device using either of the options listed above.
Figure 15: 7210 SAS-M Boot Process
Note: By default, 7210 platforms attempt the autoinit procedure unless interrupted by user and
forced to use Timos available in the flash.
OSSG325
FTP
Server
IP Address:
10.10.170.22/24
Port: 24
IP Address: 10.135.4.172/24
Gateway: 10.135.4.1
Console Cable
SAS-M
To Next Page
Loading...
