Installing Your Switch
Page 38 7210 SAS-M Installation Guide
Desktop or Shelf Mounting
Step 1 Attach the four adhesive feet to the bottom of the first switch. See Figure 12.
Figure 12: Attaching the Adhesive Feet
Step 2 Set the device on a flat surface near an external power source, making sure there are at
least three inches of space on the front and sides for proper air flow.
Step 3 If you are installing a single switch, proceed to "Grounding the Chassis" on page 39.
Step 4 If you are installing multiple switches, attach four adhesive feet to each switch. Place each
device squarely on top of the one below, in any order.
To Next Page
Loading...
