Configuring the 7210 SAS-M
7210 SAS-M Installation Guide Page 59
Enter disable since we do not want the backup link.
Press Enter.
New Settings
------------
primary-image ftp://*:*@10.10.170.22/./images/both.tim
primary-config none
#uplinkA Port Settings:
uplinkA-port 1/1/24
uplinkA-address 10.135.4.172/24
uplinkA-vlan 0
uplinkA-route 10.10.170.0/24 next-hop 10.135.4.1
#System Settings:
wait 3
persist off
console-speed 115200
Do you want to overwrite cf1:/bof.cfg with the new settings? (yes/no):
Type yes and press Enter.
The 7210 SAS-M should boot now.
Primary image location: ftp://*:*@10.10.170.22/./images/both.tim
Initializing uplinkA port using IP addr 10.135.4.172.
Loading image ftp://*:*@10.10.170.22/./images/both.tim
Version B-1.1.private, Wed Jul 15 17:18:37 IST 2009 by builder in /builder/ws/1.1B1/
main
text:(17446113-->76798004) + data:(2100172-->10874132)
Executing TiMOS image at 0x100000
…
After the 7210 SAS-M boots up, you should see the following prompt:
All rights reserved. All use subject to applicable license agreements.
Built on Wed Jul 15 17:18:37 IST 2009 by builder in /builder/ws/1.1B1/sultan
Login:
The default username and password are admin. Use it to log into the 7210 SAS-M.
Note: The status LED will be Green when the device has successfully completed the boot process
and is running normally. It is highly recommended that you change the default admin password to
prevent unauthorized access to the node.
To Next Page
Loading...
