Configuration Commands
Page 270 7750 SR OS Interface Configuration Guide
Parameters class — Identifies the scheduling class to be being overridden.
Values 1 — 8
rate rate — Overrides the HSMDA scheduler policies maximum rate for the scheduling class and
requires either the max keyword or a rate defined in megabits-per-second. In order for the rate
keyword to be specified, the scheduling class cannot be a member of a weighted scheduling
group as defined on the HSMDA scheduling policy. The rate keyword is mutually exclusive
with the weight keyword. Also, either the rate or weight keyword must be specified.
The max keyword removes any existing rate limit imposed by the HSMDA scheduler policy for
the scheduling class allowing it to use as much total bandwidth as possible.
Values 1 — 40000, max (Mbps)
weight weight-in-group — Overrides the weighted scheduler group weight for the scheduling class
as defined in the HSMDA scheduler policy. In order for a weight keyword to be specified, the
scheduling class must be a member of a weighted scheduling group as defined on the HSMDA
scheduling policy. A value represented by group-weight must follow the weight keyword. The
new weight will be used to determine the bandwidth distribution for member scheduling classes
within the group of which the scheduling class is a member.
Values 1 — 100
mcast-path-management
Syntax mcast-path-management
Context config>card>mda>ingress
Description This command enables the context to configure local MDA settings for ingress multicast path
management.
ancillary-override
Syntax ancillary-override
Context config>card>mda>ingress>mcast-mgmt
Description This command enables the context to configure ancillary path bandwidth override parameters.
path-limit
Syntax path-limit megabits-per-second
no path-limit
Context config>card>mda>ingress>mcast-mgmt>anc-override
Description This command overrides the path limits contained in the bandwidth policy associated with the MDA.
To Next Page
Loading...
