Interface Configuration
7750 SR OS Interface Configuration Guide Page 271
The no form of the command removes the path limit override from an ingress multicast path and
restores the path limit defined in the bandwidth policy associated with the MDA.
Parameters megabits-per-second — Specifies the path limit override to give the upper limit that multicast
channels may use on each path.
Values ancillary-override: 1 — 5000
primary-override: 1 — 2000
secondary-override: 1 — 2000
bandwidth-policy
Syntax bandwidth-policy policy-name
no bandwidth-policy
Context config>card>mda>ingress>mcast-mgmt
Description This command specifies an existing multicast bandwidth policy. Bandwidth policies are used to
manage the ingress multicast path bandwidth. Each forwarding plane supports multicast forwarding
paths into the switch fabric. Bandwidth policy parameters are configured in the config>mcast-mgmt
context.
Parameters policy-name — Specifies an existing multicast bandwidth policy.
primary-override
Syntax primary-override
Context config>card>mda>ingress>mcast-mgmt
Description This command enables the context to configure primary path limit override parameters.
secondary-override
Syntax secondary-override
Context config>card>mda>ingress>mcast-mgmt
Description This command enables the context to configure secondary path limit override parameters.
scheduler-policy
Syntax scheduler-policy hsmda-scheduler-policy-name
no scheduler-policy
Context config>card>mda>ingress
To Next Page
Loading...
