Configuration Commands
Page 282 7750 SR OS Interface Configuration Guide
wavetracker
Syntax wavetracker
Context config>port>dwdm
Description This command validates whether or not the port supports Wavetracker.
Default None
power-control
Syntax [no] power-control
Context config>port>dwdm>wavetracker>power-control
Description This command specifies whether the power control loop should be turned on to actively control the
laser’s launch power to the specified target power. When power-control is disabled, the launch power
is set to the laser’s maximum achievable power.
Default no power-control
Parameters no power-control — Laser output power is set to maximum.
power-control — Actively control the laser’s output power to achieve the target power.
1562.23 191.90 19 1562.64 191.85 185
1563.05 191.80 18 1563.45 191.75 175
1563.86 191.70 17
Table 29: DWDM Channel Numbers (Continued)
C-Band
100 GHz Grid 50GHz Grid
nm THz ITU
Channel
nm THz ITU
Channel
To Next Page
Loading...
