Interface Configuration
7750 SR OS Interface Configuration Guide Page 283
target-power
Syntax target-power dBm
Context config>port>dwdm>wavetracker>power-control
Description This command specifies launch power in dBm for the DWDM Wavetracker-enabled interface.
Default -20.00 dBm
Parameters power — Specify the desired average output power in dBm.
Values -22.00 — 3.00
report-alarm
Syntax [no] report-alarm [encode-fail] [encode-degrade] [power-fail] [power-degrade] [power-
high] [power-low]
The no form of the command removes the alarm parameters.
Context config>port>dwdm>wavetracker>
Description This command specifies the alarms which are enabled or outstanding against a Wave Tracker-enabled
interface.
Values encode-fail — Encoder failure
encode-degrade — Encoder degrade
power-fail — Power control failure
power-degrade — Power control degrade
power-high — Power control high limit reached
power-low — Power control low limit reached
encode
Syntax encode wave-key key2 wave-key
no encode
Context config>port>dwdm>wavetracker
Description This command specifies whether or not Wavetracker keys should be encoded on the transmitted
optical signal.
Default no encode
To Next Page
Loading...
