Configuration Commands
Page 356 7750 SR OS Interface Configuration Guide
Multilink-Bundle Port Commands
multilink-bundle
Syntax [no] multilink-bundle
Context config>port
Description This command creates the context to configure bundle properties for this bundle port.
Default None
fragment-threshold
Syntax fragment-threshold fragment-threshold
fragment-threshold unlimited
no fragment-threshold
Context config>port>multilink-bundle
Description This command sets the maximum length in bytes of a fragment transmitted across a multilink bundle.
The no form of this command resets the fragment threshold back to the default value.
Default 128
Parameters fragment-threshold — Specify the maximum fragment length, in bytes, to be transmitted across a
multilink bundle. Note that the value range is dependent on the MDA type. For example:
channelized MDAs, such as the m1-choc12-sfp, m4-choc3-sfp, m12-chds3, and m4-chds3,
support values of 128, 256, 512; ASAP channelized MDAs support any value in the valid range.
Values 128 — 512 bytes inclusive for MLPPP and MLFR bundles
128 bytes for IMA bundles
unlimited — This keyword disables fragmentation (MLPPP and MLFR only).
interleave-fragments
Syntax [no] interleave-fragments
Context config>port>multilink-bundle
Description This command enables Link Fragmentation and Interleaving on the multilink bundle.
The no form of this command disables Link Fragmentation and Interleaving on the multilink bundle.
To Next Page
Loading...
