Alcatel-Lucent 7750 SR OS - Page 357

Interface Configuration
7750 SR OS Interface Configuration Guide Page 357
member
Syntax [no] member port-id
Context config>port>multilink-bundle
Description This command binds a channel group to a multilink bundle. For IMA and MLFR groups, this
command binds a channel group filling up the entire DS-1 or E-1. MLPPP groups containing E1 links
only allow channel groups filling up the entire E1. MLPPP Groups containing DS1 links with
multiclass configured allow fractional (n x ds0) channel-groups or channel groups filling up the entire
DS1. If a MLPPP group containing DS1 links does not have multiclass configured, only channel
groups filling up the entire DS1 are allowed.
The no form of this command removes the specified channel group from the multilink bundle.
Default None
Parameters port-id — Specifies the physical port ID.
Syntax: slot/mda/port.channel
minimum-links
Syntax minimum-links minimum-links
no minimum-links
Context config>port>multilink-bundle
Description This command sets the minimum number of links that must be active for the bundle to be active.
If the number of active links drops below the configured minimum then the multilink bundle will
transition to an operationally down state.
The no form of this command removes the minimum link limit.
Default 1
Parameters minimum-link — Specify the minimum link limit, expressed as an integer.
Values 1 — 8
mlfr
Syntax mlfr
Context config>port>multilink-bundle
Description This command enables the context to configure a Multi-link Frame Relay (MLFR) bundle.