Alcatel-Lucent 7750 SR OS - Page 359

Interface Configuration
7750 SR OS Interface Configuration Guide Page 359
qos-profile
Syntax qos-profile profile-id
no qos-profile
Context config>port>multilink-bundle>mlfr>ingress
config>port>multilink-bundle>mlfr>egress
config>port>tdm>channel-group>frame-relay>egress
config>port>sonet-sdh>path>frame-relay>egress
Description This command specifies the ingress or egress QoS profile to be used for the configuration of the
ingress or egress QoS parameters of an MLFR bundle or a Frame Relay port with FRF.12 UNI/NNI
fragmentation enabled. Note that qos-profile on ingress is only applicable to MLFR.
The no form of the command removes the parameters from the configuration.
Parameters profile-id — Specifies the profile number. The value can only be modified if the MLFR bundle or FR
port is shut down.
Values 1-128
frame-relay
Syntax frame-relay
Context config>port>multilink-bundle>mlfr
Description This command configures the Frame Relay parameters.
lmi-type
Syntax lmi-type {ansi | itu | none | rev1}
Context config>port>multi-link-bundle>mlfr>frame-relay
Description This command configures the LMI type.
Parameters ansi — Use ANSI T1.617 Annex D.
itu — Use ITU-T Q933 Annex A.
none — Disable Frame Relay LMI on the given bundle.
rev1 — Use the Rev 1 version of ANSI T1.617 Annex D.