Alcatel-Lucent 7750 SR OS - Page 360

Configuration Commands
Page 360 7750 SR OS Interface Configuration Guide
mode
Syntax mode {dce | dte | bidir}
Context config>port>multilink-bundle>mlfr>frame-relay
Description This command configures the DCE/DTE mode of the Frame Relay interface.
Parameters dce — Enables the DCE mode.
dte — Enables the DTE mode.
bidir — Enables the bidirectional mode for LMI types ANSI and ITU.
n391dte
Syntax n391dte intervals
no n391dte
Context config>port>multilink-bundle>mlfr>frame-relay
Description This command confgures the number of DTE full status polling intervals for the LMI.
Parameters ntervals — The number of exchanges to be done before requesting a full-status report. A value of 1
specifies to receive full-status messages only.
Values 1 — 255
n392dce
Syntax n392dce threshold
no n392dce
Context config>port>multilink-bundle>mlfr>frame-relay
Description This command configures the DCE error threshold for the LMI.
Default 3
Parameters threshold — Specify the number of errors that will place the bundle in an operationally down state.
Values 1 — 10