Configuration Commands
Page 368 7750 SR OS Interface Configuration Guide
short-sequence
Syntax [no] short-sequence
Context config>port>multilink-bundle
Description This command specifies that the Multi-link Point to Point Protocol (MLPPP) bundle should use short
(12 bit) sequence numbers instead of the default 24-bit sequence number. This command is only valid
for MLPPP bundles.
The no form of this command disables the short-sequence feature.
Default no short-sequence
working-bundle
Syntax [no] working-bundle bundle-id
Context config>port>multilink-bundle
Description This command configures a working bundle that is part of this BPGrp.
Parameters bundle-id — Specifies the working multilink bundle in the bundle protection group. The command
syntax must be configured as follows:
Syntax: bundle-type-slot/mda.bundle-num
bundle-PPP or IMA-slot/mda.bundle-num (Creates an MLPPP or IMA bundle.)
bundle: keyword
slot: IOM/MDA slot numbers
bundle-num: 1 — 256
For example:
router1>config>port>ml-bundle> working-bundle bundle-ima-1/1.1
yellow-differential-delay
Syntax yellow-differential-delay yellow-diff-delay
no yellow-differential-delay
Context config>port>multilink-bundle
Description This command sets the yellow warning threshold for the differential delay for members within a
multilink bundle. If circuit’s delay exceeds the yellow-differential delay value, a log message and
SNMP trap is sent. This command is only valid for MLPPP bundles. The differential delay is
calculated as the round-trip differential delay for MLPPP bundles.
The no form of this command removes the yellow-differential-delay.
The no form of this command removes the yellow-differential-delay.
Default None
To Next Page
Loading...
