Interface Configuration
7750 SR OS Interface Configuration Guide Page 369
Parameters yellow-diff-delay — Specify the maximum yellow differential delay threshold value.
Values 1— 25 milliseconds
ima
Syntax ima
Context config>port>multilink-bundle
Description This command enables the context to configure parameters for an Inverse Multiplexing over ATM
(IMA) group. An IMA group is a collection of physical links bundled together and assigned to an
ATM interface. IMA enables a high-speed channel that is composed of ATM cells to be transported as
a number of lower-speed circuits. Then they are reassembled as the original high-speed ATM channel.
This command is only valid for IMA bundles.
link-delay
Syntax link-delay {activate | deactivate} milli-seconds
no link-delay {activate | deactivate}
Context config>port>multilink-bundle>ima
Description This command specifies the time to delay between detection of a link activation/deactivation
condition and acting upon it (going in/out of the RX failure state on a link).
Parameters activate milli-seconds — Specifies the time, in milli-seconds, used to clear an existing LIF or LODS
alarm. The time specified determines how long is needed for member links to stabilize before
being activated.
Values 1 — 30000 milli-seconds
Default 10000
deactivate milli-seconds — Specifies the time, in milli-seconds, used to raise an LIF or LODS alarm.
The time specified determines how long before a member link is declared in error and is
deactivated.
Values 1 — 30000 milli-seconds
Default 2000
To Next Page
Loading...
