Alcatel-Lucent 7750 SR OS - Page 370

Configuration Commands
Page 370 7750 SR OS Interface Configuration Guide
max-bandwidth
Syntax max-bandwidth number-links
no max-bandwidth
Context config>port>ml-bundle>ima
Description This command specifies the number of links that is used to determine the maximum configurable
bandwidth that is allowed to be used for this IMA group.
The maximum bandwidth is computed as:
Maximum Configurable ATM Bandwidth (MCAB) =
(number-links) * (M-1)/M * (2048/2049) * primary member link speed
where,
M is the IMA frame size (128)
primary member link speed is either E-1 — 1920kbps or DS-1 — 1539kbps. E-1 speed is used for
a group with no members.
The total ATM bandwidth of services over shaped VCs cannot exceed the MCAB value as result of
adding more services or removing member links.
The no form of the command resets the max-bandwidth to its default value
Default 8
Parameters number-links — Specifies the number of links that is used to determine the maximum configurable
bandwidth that is allowed to be used for this IMA group.
Values 1 — 8
test-pattern-procedure
Syntax test-pattern-procedure
Context config>port>ml-bundle>ima
Description This command enables the context to configure IMA test pattern procedures. Note that this command
and sub-commands are not saved in the router configuration between reboots.
test-link
Syntax test-link port-id
no test-link
Context config>port>ml-bundle>ima>test-pattern-procedure
Description This comand specifies IMA members on which an IMA test pattern procedure is to be performed.