Alcatel-Lucent 7750 SR OS - Page 428

Configuration Commands
Page 428 7750 SR OS Interface Configuration Guide
eth-cfm
Syntax eth-cfm
Context config>eth-ring>path
Description This command enables the context to configure ETH-CFM parameters.
mep
Syntax [no] mep mep-id domain md-index association ma-index
Context config>eth-ring>path>eth-cfm
Description This command provisions an 802.1ag maintenance endpoint (MEP).
The no form of the command reverts to the default values.
Parameters mep-id — ppecifies the maintenance association end point identifier.
Values 1 — 81921
md-index — Specifies the maintenance domain (MD) index value.
Values 1 — 4294967295
ma-index — Specifies the MA index value.
Values 1 — 4294967295
ccm-enable
Syntax [no] ccm-enable
Context config>eth-ring>path>eth-cfm>mep
Description This command enables the generation of CCM messages.
The no form of the command disables the generation of CCM messages.
ccm-ltm-priority
Syntax ccm-ltm-priority priority
no ccm-ltm-priority
Context config>eth-ring>path>eth-cfm>mep
Description This command specifies the priority value for CCMs and LTMs transmitted by the MEP.
The no form of the command removes the priority value from the configuration.
Default The highest priority on the bridge-port.