Configuration Commands
Page 444 7750 SR OS Interface Configuration Guide
Only files stored on the router are synchronized. If a configuration file or image is stored in a location
other than on a local compact flash, the file is not synchronized (for example, storing a configuration
file on an FTP server).
Default enabled
Parameters boot-env — Synchronizes all files required for the boot process (loader, BOF, images, and
configuration files.
config — Synchronize only the primary, secondary, and tertiary configuration files.
Default config
bgp-multi-homing
Syntax bgp-multi-homing
Context config>redundancy
Description This command configures BGP multi-homing parameters.
boot-timer
Syntax boot-timer seconds
no boot-timer
Context config>redundancy>bgp-mh
Description This command specifies how long the service manager waits after a node reboot before running the
MH procedures. The boot-timer value should be configured to allow for the BGP sessions to come up
and for the NLRI information to be refreshed/exchanged. The boot-timer is activated after the no
shutdown command for a MH site executed from configuration. Upon activation, the boot-timer is
compared with the system up-time for the node. If the boot timer is higher than the up-time, then the
service manager waits for the boot-timer-sys-up-time, then starts the site-activation-timer.
The no form of this command sets the value to 10.
Default 10 sec
Parameters seconds — Spcifies the timer, in seconds.
Values 1..100
site-activation-timer
Syntax site-activation-timer seconds
no site-activation-timer
Context config>redundancy>bgp-mh
To Next Page
Loading...
