Interface Configuration
7750 SR OS Interface Configuration Guide Page 445
Description This command defines the amount of time the service manager will keep the local sites in standby
status, waiting for BGP updates from remote PEs befoer running the DF election algorithm to decide
whether the site should be unblocked. THe timer is started when one of the following event occurs
only if the site is opporationally up:
• Manual site activation using “no shutdown” at site-id level or at member object(s) level (for
example, SAP(s) or PW(s)
• Site activation after a failure
The no form of this command sets the value to 2.
Default 2 seconds
Parameters seconds — Spcifies the timer, in seconds.
Values 1..100
multi-chassis
Syntax multi-chassis
Context config>redundancy
Description This command enables the context to configure multi-chassis parameters.
peer
Syntax [no] peer ip-address create
Context config>redundancy>multi-chassis
Description Use this command to configure up to 20 multi-chassis redundancy peers. Note that is is only for mc-
lag (20) not for mc-sync (4).
Parameters ip-address — Specifies the IP address.
Values ipv4-address: a.b.c.d
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
create — Mandatory keyword specifies to create the peer.
To Next Page
Loading...
