Configuration Commands
Page 456 7750 SR OS Interface Configuration Guide
Description This command specifies the destination IP address used in the inband control connection. If the
address is not configured, the ring cannot become operational.
Parameters ip-address — Specifies the destination IP address.
interface
Syntax interface ip-int-name
no interface
Context config>redundancy>mc>peer>mcr>ring>in-band-control-path
Description This command specifies the name of the IP interface used for the inband control connection. If the
name is not configured, the ring cannot become operational.
service-id
Syntax service-id service-id
no service-id
Context config>redundancy>mc>peer>mcr>ring>ibc
config>redundancy>mc>peer>mcr>node>cv
Description This command specifies the service ID if the interface used for the inband control connection belongs
to a VPRN service. If not specified, the service-id is zero and the interface must belong to the Base
router.
The no form of the command removes the service-id from the IBC configuration.
Parameters service-id — Specifies the service ID if the interface.
Values service-id: 1 — 2147483647
path-b
Syntax [no] path-b
Context config>redundancy>mc>peer>mcr>ring
Description This command specifies the set of upper-VLAN IDs associated with the SAPs that belong to path B
with respect to load-sharing. All other SAPs belong to path A.
Default If not specified, the default is an empty set.
To Next Page
Loading...
