Alcatel-Lucent 7750 SR OS - Page 539

Interface Configuration
7750 SR OS Interface Configuration Guide Page 539
The following output displays an example of a standalone PPP link:
*A:top_SR7# show port 3/1/4.1.2.3.1 ppp
===============================================================================
PPP Protocols for 3/1/4.1.2.3.1
===============================================================================
Protocol State Last Change Restart Count Last Cleared
-------------------------------------------------------------------------------
lcp initial 05/24/2008 11:25:23 1 05/22/2008 06:28:48
ipcp initial 05/22/2008 06:28:48 0 05/22/2008 06:28:48
mplscp initial 05/22/2008 06:28:48 0 05/22/2008 06:28:48
bcp initial 05/22/2008 06:28:48 0 05/22/2008 06:28:48
osicp initial 05/22/2008 06:28:48 0 05/22/2008 06:28:48
ipv6cp initial 05/22/2008 06:28:48 0 05/22/2008 06:28:48
===============================================================================
PPP Statistics
===============================================================================
Local Mac address : 00:16:4d:8f:d3:57 Remote Mac address :
Local Magic Number : 0x0 Remote Magic Number: 0x0
Local IPv4 address : 0.0.0.0 Remote IPv4 address: 0.0.0.0
Local IPv6 address : ::
Remote IPv6 address: ::
Line Monitor Method: keepalive
Keepalive statistics
Request interval : 4 Threshold exceeded : 0
Drop Count : 3 In packets : 46418
Time to link drop : 00h00m12s Out packets : 46418
Last cleared time : 05/22/2008 06:28:48
PPP Header Compression
ACFC : Enabled PFC : Enabled
===============================================================================
*A:top_SR7#
ATM Output — The following table describes ATM output fields.
Label Description
Cell Mode
Displays the cell format (UNI or NNI) that is used on the ATM inter-
face.
Configured VCs
Displays the number of configured VCs.
Max Supported
VCs
Indicates the maximum number of ATM VPCs that can be configured
on this MDA.
Interface Oper
Status
Indicates the status of the ATM interface. If the SONET-PATH layer
and TC sublayer are operationally up, the ATM Interface is considered
up. If the SONET-PATH layer and/or TC SubLayer is down, the ATM
Interface is set to lowerLayerDown.
Number OCD
Events
Displays the number of times the Out of Cell Delineation (OCD) events
occurred