Alcatel-Lucent MDR-8000 - MDR-8000 Synchronous Repeater Compatibility Matrix; MDR-8000 Synchronous Repeater Cables

3-8
Having the radio overhead multiplexed together into a standard T1
also allows the overhead to be transported over non-Alcatel radio facil
-
ities (i.e., channel banks, fiber optic terminals, or no-Alcatel radio
equipment). This feature is extremely useful in SONET rings where
part of the ring will be MDR-8000s OC3 radio and part will be SONET
fiber equipment.
3.5.4 MDR-8000 Synchronous Repeater Compatibility Matrix
Table 3 - 1 lists the combinations of MDR-8000 capacities that support the use of the syn-
chronous repeater cable.
3.5.5 MDR-8000 Synchronous Repeater Cables
Refer to Table 3 - 2.
Notes:
1 For both High and Low capacity applications, refer to drawing number
3DH031770000EJZZA for the specific cable connections.
2 The MDR-8000 Synchronous Repeater Cable part number is the same for both
the DS1 and D3 versions of the radio. Refer to drawing number
3DH031770000BJZZA for cable dash numbers and lengths.
Table 3 - 1 Synchronous Repeater Compatibility
Radio #1
Capacity
Radio #2 Capacity
DS1 DS3 OC3
2 4 8 12 16 1 3
10
MHz
30
MHz
2 DS1 X
4 DS1 X X X X
8 DS1 X X X X
12 DS1 X X X X
16 DS1 X X X X
1 DS3 X X
3 DS3 X X
OC3
(10 MHz)
X X
OC3
(30 MHz)
X X
X denotes allowable combinations of use
Note