3-23
3.14 OC3/STM-1 REPEATER (J203 ON ONE SHELF TO J203 ON SECOND SHELF)
The OC3/STM-1 radio repeater cable carries clocks, data, and over-
head for two directions. It does not carry OC3/STM-1 or Wayside DS1
traffic. OC3/STM-1 fiber optic cables and Wayside DS1 cables must be
run separately. If the repeater cable is not used, the embedded data in
the overhead must be cabled individually. In this case, separate cables
must be run for MCS-11, audio, RS-232, and ELMC.
Recommended connectorized cable assembly – PN 695-4125-007/013 (26 AWG 5 pair
shielded, jacketed cable). See
Figure 3 - 14 for shelf connector location and pinout. Refer to
CD for mating cable wiring and color code.
Use repeater cables for cabling repeater shelf 1 to repeater shelf 2 (east-
bound/westbound data/clock)
Figure 3 - 14 Repeater Connector – OC3/STM-1 AUX Interface
Note
Note
J315
J301
J313
J308 J309 J310 J312
J318
J305
J316 J317 J302
J307
J203
FRONT VIEW
51
96
GND
RPTR DS1 OUT TIP
RPTR DS1 IN TIP
RPTR DS1 OUT RING
RPTR DS1 IN RING
LMW-7067
07/23/02
J301
To Next Page
Loading...
