This function is only available if your installation is fitted with DECT functions
The ARI (Access Right Identifier) number identifies the system uniquely to mobiles. It contains
11 octal digits (base 8). This number, assigned to an ETSI base by the installer, must be
entered on installing the system.
The first digit cannot be modified and is always set to 1. The cursor is automatically placed on
the second. The last digit is always either 0 or 4.
Note:
This is only relevant for IBS-DECT solution.
6.1.1.10 AUTHENTICATION
This is used to make secure data transmission between the system and DECT mobiles by
using an authentication code during registration
: choice between "off" and "on".
If the authentication mechanism is "on", the following screen is displayed.
Each access code can have a maximum of ten digits. This can be limited to the first four digits
if there are DECT stations other than the 100/200 Mobiles.
6.1.1.11 USER INFORMATION LANGUAGE
+
6-7
To Next Page
Loading...
Need help?
General
