Alcatel-Lucent OmniSwitch 10K - Page 129

OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 129 of 148
Below is an example:
-> show lanpower slot 1/1 priority-disconnect
Priority Disconnect enabled on ChassisId 1 Slot 1
4. Usage-threshold:
This feature is set at 99(%) aby default. The switch checks for a user-defined, slot-wide threshold for PoE
power usage, in percent. When the usage threshold is reached or exceeded, a notification is sent to the user.
-> show lanpower slot <chassis/slot> usage-threshold
Below is an example:
-> show lanpower slot 1/1 usage-threshold
Usage Threshold 99% on ChassisId 1 Slot 1
5. Power Priority:
The default power priority is Low.
• Low. This default value is used for port(s) that have low-priority devices attached. In the event of a power
management issue, inline power to low-priority is interrupted first (i.e., before critical and high priority).
• High. This value is used for port(s) that have important, but not mission-critical, devices attached. If others in
the chassis have been configured as critical, inline power to high-priority is given second priority.
• Critical. This value is used for port(s) that have mission-critical devices attached, and therefore require top
(i.e., critical) priority. In the event of a power management issue, inline power to critical is maintained as long
as possible.
Below is an example:
-> show lanpower slot 1/1
Port Maximum(mW) Actual Used(mW) Status Priority On/Off Class Type
----+-----------+---------------+-----------+---------+--------+-------+----------
1 30000 0 Searching Low ON *
2 30000 0 Searching Low ON *
3 30000 0 Searching Low ON *
….