Alcatel-Lucent OmniSwitch 10K - Page 21

OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 21 of 148
increase. Under normal conditions this counter should ideally
be one unit greater than the counter for the opposite transitions
from operational up to down
Troubleshooting in maintenance shell :
Port status in the hardware. To check if the ports which are mapped to VFL are in forwarding state, list device
ports providing device port numbers. When a port is configured as a VFL, it is renamed from xeM to hgN,
where M and N are numbers.
OS6860-> su
Entering maintenance shell. Type 'exit' when you are done.
SHASTA #-> bShell
Entering character mode
Escape character is '^]'.
Broadcom Command Monitor: Copyright (c) 1998-2010 Broadcom Corporation
Release: sdk-6.3.4 built ()
From @:7.1.1.R01
Platform: unknown
OS: Unix (Posix)
BCM.0> ps
ena/ speed/ link auto STP lrn inter max loop
port link duplex scan neg? state pause discrd ops face frame back
ge0 down - SW Yes Block None FA SGMII 9216
ge1 down - SW Yes Block None FA SGMII 9216
ge2 down - SW Yes Block None FA SGMII 9216
.
.
.
.
.
xe1 !ena 10G FD None No Block None FA XFI 9216
xe2 !ena 10G FD None No Block None FA XFI 9216
xe3 !ena 10G FD None No Block None FA XFI 9216
hg0 up 21G FD HW Yes Forward None FA XGMII 16360
hg1 up 21G FD HW Yes Forward None FA XGMII 16360
To collect debug traces and data either to a file or, if no file is specified to the standard output use the
command "debug dump virtual-chassis type {trace | data | all} chassis-id <chassis-id> slot {<slot-id> | all}
[output-file <filepath/filename>]". Example:
The logs provided complete log about the VC states,VFL linkstates, VC Event-traces,etc.
OS6860->
flash/vc_debug.txtp virtual-chassis chassis-id 1 type all slot all output-file /
Please wait......................................................
Output File : /flash/vc_debug.txt successfuly created (size 670822 bytes)
OS6860-> cat vc_debug.txt
ack, : Request acknowledgment {1 = true, 0 = false}
dump) : Request packet dump {1 = true, 0 = false}
> vcm_debug_socket
socket, : Socket < 0 => debug reactor all sockets only
debugAllSock,: 1/0 enable/disable all socket debug
debugReac : 1/0 enable/disable reactor debug
Public msg traces and statistics
--------------------------------------------------------------------------------
> vcm_show_public_trace (start, count, detail)
show range of public messages in the trace buffer. Use start = 0 and count = 0