NTP Specifications Configuring Network Time Protocol (NTP)
page 4-2 OmniSwitch 6250/6450 Switch Management Guide May 2012
NTP Specifications
NTP Defaults Table
The following table shows the default settings of the configurable NTP parameters:
NTP Defaults
RFCs supported 1305–Network Time Protocol
Platforms Supported OmniSwitch 6250, 6450
Maximum number of NTP servers per client 3
Parameter Description Command Default Value/Comments
Specifies an NTP server from which
this switch receives updates
ntp server version: 4
minpoll: 6
prefer: no
key: 0
Used to activate client ntp client disabled
Used to activate NTP client
broadcast mode
ntp broadcast disabled
Used to set the advertised broadcast
delay, in microseconds
ntp broadcast-delay 4000 microseconds
To Next Page
Loading...
