Managing Switch User Accounts Setting Up End-User Profiles
OmniSwitch 6250/6450 Switch Management Guide May 2012 page 9-33
Creating End-User Profiles
To set up an end-user profile, use the aaa admin-logout command and enter a name for the profile. Spec-
ify read-only or read-write access to particular command areas. The profile can also specify port ranges
and/or VLAN ranges. The port ranges and VLAN ranges must be configured on separate command lines
and are discussed in the next sections.
In this example, a profile is created with access to physical commands on the switch:
-> end-user profile Profile3 read-write physical
A profile named Profile3 is now available on the switch and can be associated with a user through the
user command.
If port ranges or VLAN ranges are not configured, a user with this profile will not be able to use any
commands that require port or VLAN values or view any show outputs that contain port or VLAN values.
To Next Page
Loading...
