Alcatel-Lucent OmniSwitch 6800 Series - Webview CLI Commands; Enabling;Disabling Webview; Changing the HTTP Port; Enabling;Disabling SSL

Using WebView WebView CLI Commands
OmniSwitch 6800/6850/9000 Switch Management Guide December 2007 page 9-3
WebView CLI Commands
The following configuration options can be performed using the CLI. These configuration options are also
available in WebView; but changing the web server port or secured port may only be done through the
CLI (or SNMP).
Enabling/Disabling WebView
WebView is enabled on the switch by default. If necessary, use the http server command to enable
WebView. For example:
-> http server
Use the no http server command to disable WebView on the switch. If web management is disabled, you
will not be able to access the switch using WebView. Use the show http command to view WebView
status.
As an alternative you can use the https keyword instead of the http keyword to enable WebView. For
example:
-> https server
When using this format of the command use the no https server command to disable WebView on the
switch.
Changing the HTTP Port
The default HTTP port is 80, the well-known port number for Web servers. You can change the port to a
number in the range 0 to 65535 using the http port command. (Well-known port numbers, which are in
the range 0 to 1023, cannot be configured.)
Note. All WebView sessions must be terminated before the switch will accept the command.
For example:
-> http port 2000
This command changes the HTTP port to 2000.
To restore an HTTP port to its default value, use the default keyword as shown below:
-> http port default
Enabling/Disabling SSL
Force SSL is disabled by default. Use the http ssl command to enable Force SSL on the switch. For exam-
ple:
-> http ssl
Use the no http ssl command to disable Force SSL on the switch. Use the show http command to view
WebView status.