Alcatel-Lucent OmniSwitch 6800 Series - Page 44

Loading Software onto the Switch Managing System Files
page 1-24 OmniSwitch 6800/6850/9000 Switch Management Guide December 2007
Note. FTPv6 sessions are supported only on the OmniSwitch 6850 or 9000. It is mandatory to specify the
name of the particular IPv6 interface, if the FTPv6 server has been specified using its link-local address.
3 Set the client to binary mode with the bin command. Enter a valid user name and password for the host
you specified with the ftp command. A screen similar to the following is displayed:
Name: Jsmith
331 Password required for Jsmith
Password: *****
230 User Jsmith logged in.
4 After logging in, you will receive the ftp-> prompt. You may enter a question mark (?) to view
available FTP commands as shown here.
ftp->?
Supported commands:
ascii binary bye cd delete
dir get help hash ls
put pwd quit remotehelp user
lpwd mput mget prompt !ls
lcd user
These are industry standard FTP commands. Their definitions are given in the following table:
ascii Set transfer type to ASCII (7-bit).
binary Set transfer type to binary (8-bit).
bye Close session gracefully.
cd Change to a new directory on the remote machine.
delete Delete a file on the remote machine.
dir Obtain a long listing on the remote machine.
get Retrieve a file from the remote machine.
hash Print the hash symbol (#) for every block of data transferred.
(This command toggles hash enabling and disabling.)
help Displays a list of FTP commands and their definitions.
ls Display summary listing of the current directory on the remote
host.
put Send a file to the remote machine.
pwd Display the current working directory on the remote host.
quit Close session gracefully.
remotehelp List the commands that the remote FTP server supports.
user Send new user information.
lpwd Display the current working directory on the local host.
mput Allows for the transfer of multiple files out of the local machine.
mget Allows for the transfer of multiple files into the local machine.
prompt Toggles the query for use with the mput and mget commands.