Alcatel-Lucent OmniSwitch AOS Release 6 - Configuring Network Time Protocol (NTP); NTP Specifications; NTP Defaults Table

NTP Specifications Configuring Network Time Protocol (NTP)
page 4-2 OmniSwitch AOS Release 6 Switch Management Guide July 2010
NTP Specifications
NTP Defaults Table
The following table shows the default settings of the configurable NTP parameters:
NTP Defaults
RFCs supported 1305–Network Time Protocol
Platforms Supported OmniSwitch 6400, 6850, 6855, 9000, 9000E
Maximum number of NTP servers per client 3
Parameter Description Command Default Value/Comments
NTP server functionality ntp interface Enabled on all interfaces
Specifies an NTP server from which
this switch will receive updates
ntp server version: 4
minpoll: 6
prefer: no
key: 0
Used to activate client ntp client disabled
Used to activate NTP client
broadcast mode
ntp client disabled
Used to set the advertised broadcast
delay, in microseconds
ntp broadcast-delay 4000 microseconds