Alcatel-Lucent OmniSwitch AOS Release 6 - Displaying CMM Conditions

Displaying CMM Conditions Managing CMM Directory Content
page 5-36 OmniSwitch AOS Release 6 Switch Management Guide July 2010
Displaying CMM Conditions
To show various CMM conditions, such as where the switch is running from and which files are installed,
use the following CLI show commands:
For more information on the resulting displays from these commands, see the OmniSwitch CLI Reference
Guide. An example of the output for the show microcode command is given in “Show Switch Files” on
page 5-24.
show running-directory Shows the directory from where the switch was booted.
show reload Shows the status of any time delayed reboot(s) that are pending on the
switch.
show microcode Displays microcode versions installed on the switch.
show microcode history Displays the archive history for microcode versions installed on the
switch.