Creating Snapshot Configuration Files Working With Configuration Files
page 7-10 OmniSwitch AOS Release 6 Switch Management Guide July 2010
Creating Snapshot Configuration Files
You can generate a list of configurations currently running on the switch by using the configuration
snapshot command. A snapshot is a text file that lists commands issued to the switch during the current
login session.
Note. A user must have read and write permission for the configuration family of commands to generate a
snapshot file for those commands. See the “Switch Security” chapter of this manual for further informa-
tion on permissions to specific command families.
Snapshot Feature List
You can specify the snapshot file so that it will capture the CLI commands for one or more switch features
or for all network features. To generate a snapshot file for all network features, use the following syntax:
-> configuration snapshot all
To generate a snapshot file for specific features, select the appropriate syntax from the following list.
You may enter more than one network feature in the command line. Separate each feature with a space
(and no comma). The following command will generate a snapshot file listing current configurations for
the vlan, qos, and snmp command families.
-> configuration snapshot vlan qos snmp
You can verify that a new snapshot file is created by using the ls command to list all files in the /flash
directory.
Snapshot Keywords
802.1Q ipx snmp
aaa ip-routing stp
aip linkagg system
all module slb
bgp ntp vrrp
bridge ospf vlan
chassis ospf3 webmgt
health pmm
ip policy
ipms qos
ipv6 rip
ipmr ripng
ip-helper rdp
interface session
To Next Page
Loading...
