Configuring the Switch With WebView Using WebView
page 12-14 OmniSwitch AOS Release 6 Switch Management Guide July 2010
2 Complete the fields, then click Apply. The new configuration takes effect immediately and the new
entry appears in the table.
3 Repeat steps 1 and 2 to add additional entries.
Add Window
Modifying an Existing Entry
To modify an existing entry:
1 Click on the checkbox to the left of the entry on the Configuration page and click Modify. The Modify
window appears (e.g., Modify IP Static Route). The current configuration is displayed in each field.
2 Modify the applicable field(s), then click Apply. If successful, the Modify window disappears. The
new configuration takes effect immediately and the modified entry appears in the table. If there is an error,
the window will remain and an error message is displayed.
3 Repeat the procedure to modify additional entries.
Modify Window
To Next Page
Loading...
