8AL90344ENAAed01 16
OmniTouch™ 8128 SE WLAN Handset
3.2.3 Battery Pack Charger
The battery pack charger (CR4) is used to charge up to six spare batteries.
Refer to the Installation Guide, CR4 Battery Pack Charger, TD 92883EN.
3.2.4 Clip
NOTE: It is possible to use the handset without any attached clip, see 11.4 Attach
Cover for No Clip on page 53.
NOTE: The belt clips cannot be used if the handset is placed in a case. See 3.2.6
Leather Casing on page 16 for more information.
There are two belt clips available:
• Hinge-type clip
To prevent the handset from slipping out of, for example, a pocket or belt, see 12.
Troubleshooting on page 53.
• Swivel-type clip
To be able to rotate the handset without slipping out from, for example, a pocket or
belt, see 11.3 Attach the Swivel-type Clip on page 52.
3.2.5 Security Cord
The security cord is 800 mm long. It is attached directly to the handset.
3.2.6 Leather Casing
The leather casing is specially designed for the handset. The casing comes with a
swivel type belt clip, and the handset is fully operational while it is placed in the casing.
3.2.7 Headset
A headset is recommended if the handset is frequently used and/or if the user wants to
have both hands free. The headset comes in two versions; microphone integrated in
the cable or microphone on a boom. It is also possible to use any headset with a 2.5
mm connector and configure parameters for the headset using the user’s headset
profile
To achieve optimal audio quality with the different headset types, it is recommended to
select the corresponding headset profile. See 7.6.1 Headset on page 46 for more
information.
To Next Page
Loading...
