8AL90344ENAAed01 28
OmniTouch™ 8128 SE WLAN Handset
6.3.4 Start New Call During Conversation
NOTE: If configured in the Device Manager, it is possible to make an emergency call
while the handset/keypad is locked. During the ongoing emergency call, the soft
key “More” is disabled.
1 Press “More” during the call.
2 Select “New Call”. The first call is automatically put on hold.
3 Press “Select”.
4 Enter the number or pr press to access the phonebook.
5 Press , or “Call”.
6.3.5 Switch Between Calls
To switch between two ongoing calls:
1 Select the call on hold using the Navigation key.
2 Press the left soft key “Retr.”.
The retrieved call is indicated with . The call on hold is indicated with .
6.3.6 End Call
Prerequisite: A new call has been started during the conversation, see 6.3.4 Start New
Call During Conversation on page 28.
1 Select the call to end by using Up and Down on the Navigation key.
2 Press the right soft key “End”. The selected call ends.
3 If needed, press the left soft key “Retr.” to resume the remaining call.
6.3.7 Transfer Call
Prerequisite: There are two ongoing calls.
1 Select the call on hold using Up and Downon the Navigation key.
2 Press “More”.
3 Select “Transfer to”. The two calls are connected. “Transferred” is displayed and
the handset enters idle mode.
6.3.8 Transfer to New Call
Prerequisite: There is one ongoing call.
1 Press “More” during the call.
2 Select “Transf. to new”.
3 Press “Select”.
4 Enter the number to which the other party will be connected. It is also possible to
make a phonebook lookup to select a contact in the local phonebook and
the company phonebook.
5 Press “OK” or to transfer the call.
To Next Page
Loading...
