8AL90344ENAAed01 30
OmniTouch™ 8128 SE WLAN Handset
6.4 Loudspeaking Function
There are two ways to activate loudspeaking:
• When receiving a call, press the middle soft key .
• During a call, press the left soft key .
To turn off loudspeaking, press the left soft key .
This function can also be activated by selecting the answering method “Loudspeaking”.
See 7.5.5 Answering on page 45.
6.5 Call Diversion
All calls; internal calls, external calls, calls when busy, or calls at no answer can be
diverted to another handset number. The diversion is made via the Divert calls menu.
See 7.1.3 Call Diversion on page 33 or edit the Profile, see Edit Profile on page 37.
It is also possible to program a Soft key, Hot key, or Multifunction button with a shortcut
to the “Call diversion” menu. Refer to 7.4 Shortcuts on page 38, and Divert All Calls on
page 33.
Depending on if the SIP or H323 protocol is used, the Call Diversion differs when the
handset is out of range of the VoWiFi network. Using the SIP protocol, the Call
Diversion function is managed by the handset and the Call Diversion does not work
until the handset is within range again. Using the H323 protocol, the Call Diversion
function is managed by the PBX and is available in the handset, even if it is out of
range. The protocol used can be viewed in the Administration menu in the Device
Manager.
6.6 Emergency Calls
If configured in the WinPDM/Device Manager, any one of up to five predefined
emergency numbers can be called, even if the handset or keypad has been locked. For
additional information, see section 7.5.2 Locks
To Next Page
Loading...
