Alcatel-Lucent OmniTouch 8128 SE - Missed Calls; Call Diversion

8AL90344ENAAed01 33
OmniTouch™ 8128 SE WLAN Handset
7.1.2 Missed Calls
NOTE: Also declined calls are counted as missed calls.
1 Enter the menu by pressing the “Menu” soft key.
2 Select “Calls” in the menu.
3 Press “Select”.
4 Select “Missed calls”.
5 Step with Up and Down to select number in the list.
6 Press “Call”, or to call back.
As in the Call list, there is a Soft Key “More” which can be used to view the time/date of
the call, edit the received number, add to contacts, delete received numbers. See 7.1.1
Call List on page 31 for information about the functionality in Soft Key “More”.
NOTE: If supported by the system, the number’s contact name can be displayed in the
list.
7.1.3 Call Diversion
NOTE: This function is system-dependent. The parameters are set up in the Device
Manager, refer to the Configuration Manual, WLAN Handset, TD 92923EN.
Divert All Calls
1 Enter the menu by pressing the “Menu” soft key.
2 Select “Calls” in the menu.
3 Select “Divert calls” .
4 Select “All calls” > “Edit”.
5 Enter number (maximum 24 digits) to divert to.
6 Select “OK” or “Back” > “Yes”. The check box is marked.
7 Press “Back” until the screen turns to idle mode.
The handset sends a diversion reason code to the system when establishing a call.
The call is automatically disconnected after a few seconds.
8 To stop the diversion select “All calls” and unmark the check box. Press the Soft
Key “Back” until the screen turns to idle mode.
Divert Calls if No Reply
1 Enter the menu by pressing the “Menu” soft key.
2 Select “Calls” in the menu.
3 Select “Divert calls” .
4 Select “No reply” > “Edit”.
5 Enter number (maximum 24 digits) to divert to.
6 Select “OK” or “Back” > “Yes”. The check box is marked.
7 Press “Back” until the screen turns to idle mode.
The handset sends a diversion reason code to the system by establishing a call.
The call is automatically disconnected after a few seconds.
8 To stop the diversion, select “All calls” and unmark the check box. Press the Soft
Key “Back” until the screen turns to idle mode.