8AL90344ENAAed01 49
OmniTouch™ 8128 SE WLAN Handset
9. Operation Notice
9.1 Accessibility and Voice Quality
The WLAN network is not always available. If you do not get in contact with your
system, contact your system administrator. For best voice quality, avoid positioning
near computer, radio or similar equipment.
Operating Area
You can only use the handset in the area that is covered by your system. Outside this
area you lose contact with the system. The signal strength icon is low and the text
“No network” appears in the display.
Out of Range (No network)
When you leave the system's coverage area, the handset will by default indicate with a
short beep, and the text “No network” appears in the display in idle mode. It also
indicates with a simultaneous red LED, vibrator (if enabled), and a dialog window (if
enabled by your system administrator).
The indication is by default repeated every minute for 30 minutes. You can turn the
sound off by using a long press on , or . The Volume button (down) can also
be used. It can also be set to indicate only once, or be turned off completely, contact
your system administrator.
TIP: Even if “Indication off” is set, the “No network” (or “No access” which means that
there’s neither voice, nor messaging connection) dialog window (popup) still can
appear as a completely silent indication. Contact your System Administrator.
When re-entering the coverage area, it can take a couple of minutes before the
handset automatically has registered in the system.
To Next Page
Loading...
