• no VLAN has to be configured.
4.7.1.2.5.1 Prerequisites
None.
4.7.1.2.5.2 Relocating and retaining the same set
To relocate and retain the same set:
1. Unplug the set.
2. Plug the set into a connector at its new location.
4.7.1.3 Rebooting the set
To reboot a set:
1. In OMC, go to Users/Base stations List > Details.
2. Click Reset button.
The Reset window opens.
3. Select Reboot and click OK.
4. In the confirmation window, click Yes.
4.8 8029/8039 Premium DeskPhones
4.8.1 Commissioning
4.8.1.1 Connecting the set
4.8.1.1.1 Physical connection
To connect the set to the OXO Connect:
1. Plug the RJ11 cable in the corresponding set connector on the back of the set
2. Plug the other end of the cable onto the UA board on which the set has been declared
The set starts initializing automatically.
If this is the first set initialization, or when there has been an upgrade of the PBX software version,
the set downloads binary and data files.
4.8.1.1.2 Connecting an Add-On module to the sets
Add-On Modules (AOMs) can be connected to sets. They are added to the right side of the set.
Three types of Add-On Module exist and provide keys associated with icons:
• AOM10 provides 10 keys
• AOM40 provides 40 keys
• Smart Display Module provides 14 keys with programmable LCD labels
4.8.1.1.2.1 Rules and restrictions
The following rules apply to the use of Add-On Modules:
• A maximum of three Add-On Modules of the types AOM10 and AOM40 can be connected to each
set, providing up to 120 additional keys.
• A maximum of three Smart Display Modules can be connected to each set, providing up to 42
additional keys.
• Add-On Modules of types AOM10 and AOM40 can be used on the same set, but a Smart Display
Module cannot be used in conjunction with an AOM10 or AOM40.
Chapter
4
Installation and Cabling
3EH21123USAA - Ed. 01 - April 2017 - Installation Manual 105/207
To Next Page
Loading...
Need help?
General
