Alcatel GO FLIP User Manual

Set Up Your Phone 10
Insert an SD Card
Follow these steps to insert an optional SD card (not included). Make sure to power your phone off before
inserting or removing an SD card.
1. Remove the battery cover and battery. (See Remove the Battery.)
2. Insert SD card.
 Insert SD card all the way gently without bending and with terminals facing down.
 Insert only SD cards.
3. Insert the battery and replace the battery cover. (See Insert the Battery.)
 Align the contacts of the battery with the contacts in the phone.
 Make sure all the tabs are secure and there are no gaps around the cover.
Remove an SD Card
Follow these instructions to remove an SD card. Always power the phone off before inserting or removing an
SD card.
1. Remove the battery cover.
 Lift gently in the direction shown.

Alcatel GO FLIP Specifications

General

Internal Storage	4 GB
Expandable Storage	microSD up to 32 GB
Rear Camera	2 MP
Battery	1350 mAh
Operating System	KaiOS
SIM	Nano-SIM
Connectivity	Wi-Fi, Bluetooth
Network	4G LTE
Weight	118g
Dimensions	108.5 x 54.7 x 18.7 mm