Alcatel IP1020P - Basic Configuration Using IP20 Handset Keypad

Alcatel IP1020 Administrator Guide ed1.0 10/58
(usually it is the same as your phone number).
Registered Name
Register name provided by your VoIP Service Provider.
Password
Account password provided by your VoIP Service Provider.
Fill them in according to the information provided by your VoIP Service Provider, and
scroll down the page to press “Save” button.
Once Network and Account Setting configurations are settled and your phone
registered, your handset will show the content of Account Name parameter on the
screen. Otherwise it will show “No service”.
You can also check Account status table in StatusLine status page to see if
registration has been successful. Please read chapter about Status in next chapter
“Customizing your phone”.
Note:
Should the IP PBX (SIP registrar) require an authentication, a correct password is
needed. Make sure you are enter the right password via the web user interface.
Note:
If you are using more than one handset and/or more than one sip account, please read
section Call Routes in chapter Customizing your system for additional possibilities
in terms of customization
1.3.2 Basic Configuration using IP20 handset keypad
You will need admin privilege to perform this and other configurations. You will be asked
for the admin password when performing some of the configurations. By default the
admin password is 0000
Network Settings: Press MENU System Network Settings. Enter the admin
password, choose either DHCP or Fixed IP, and fill in the relevant fields. When you
have finished press “Save” softkey. Please note the system will reboot to make the
changes effective.
Note:
Using the wrong network parameters may result in inaccessibility of your phone and
may also have an impact on your network performance. Please contact your network
administrator.