17
17
AFTER SALES SUPPORT
1300 889 028 (toll free)
e-mail:
info.aldi@positecgroup.com
CPS18WA.9 • 2323 • 05/2019
MODEL No.:
CPS18WA.9 • 2323 • 05/2019
8.3. Orbital sanding
Your sander operates in small circular rotations which allows
efficient material removal.
Operate the sander in long sweeping movements across your
workpiece and even across the grain. For a finer finish, always use a
fine grain sandpaper and only move the sander in the direction of
the grain and never across the grain.
Do not allow the sander to remain in the same position otherwise
you will remove material and create an uneven surface.
8.4. SDS finger pad (See fig. H1, H2)
This sander has a finger pad (8), which is suitable for fine sanding in
corners, edges, or hard-to reach areas. Start the sander then apply
the finger pad to the work piece.
H1 H2
9. Maintenance
Remove the battery pack from the tool before carrying out
any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free of
dust. Occasionally you may see sparks through the ventilation slots.
This is normal and will not damage your power tool.
To Next Page
Loading...
Need help?
General
